Sanyo CLT-5810 - Manual (Page 21)

E19
DIRECTORY
Memory Dialing allows you to dial a number by pressing just a
few keys.
Your cordless phone stores up to 10 names/numbers in the handset.
Storing phone numbers and names
1
Press the MEM key in standby mode.
¨
Select Memory ¨ is displayed.
2
Press the VOL/RING or VOL/RING key, or enter a number
(0 - 9) to select the memory location where you would like to
store the number.
3
Press the MEM or SELECT key.
4
Press the MEM or SELECT key again.
¨
Store Name ¨ appears and a cursor
flashes indicating that the display is
ready for the name to be entered.
If the Edit screen appears, the selected
memory location is already stored. Then
you must either edit the entry in this
location, delete the entry in this location,
or select ¨
Go Back ¨ to choose another location.
5
To enter a name (up to 13 characters), use the number keys.
• See the "Steps for entering names and special characters."
(See page E21).
• Use the #/ and /TONE/ keys to move the cursor to the
desired location.
• Use the DELETE/CH key to delete characters as needed.
• Press and hold the DELETE/CH key to delete all the characters.
• If a name is not required, go to step 6.
In memory dialing operation, you must press a key within 30 seconds or the
phone will return to standby mode. If you return the handset to the base, the
phone will return to standby mode also.
Note:
Select Memory
01
02 Alison
Store Name
Edit Memory01
Delete Memory01
Go Back
01:(Empty)
Press Select
to edit
UP015DH(CLT5810) ENG OM 3/9/05 10:36 AM Page 19