Listening to the radio, Basic operation – Sharp SD-AT50 User Manual
Page 30
E-25
SD-AT50(U)E3.fm
02/7/19
SD-AT50
ENGLISH
DX-AT50
B
asic Operation
- Lis
te
ning
t
o
the
ra
dio -
Listening to the radio
[Front]
To receive an FM stereo transmission:
Press the BAND button to display the "STEREO" indicator.
!
"ST" will appear when an FM broadcast is in stereo.
!
If the FM reception is weak, press the BAND button to extinguish the "STEREO"
indicator. The reception changes to monaural, and the sound becomes clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the FUNCTION button to display FM or AM, and then the
BAND button repeatedly to select the desired frequency band (FM
STEREO, FM or AM).
3
Press the
or
button to tune in to the desired station.
Manual tuning:
Press the
or
button as many times as required to tune in to the desired
station.
Auto tuning:
When the
or
button is pressed for more than 0.5 seconds, scanning will
start automatically and the tuner will stop at the first receivable broadcast station.
Notes:
!
When radio interference occurs, auto scan tuning may stop automatically at
that point.
!
Auto scan tuning will skip weak signal stations.
!
To stop the auto tuning, press the
or
button again.
FM stereo receiving indicator
FM stereo mode indicator