Sharp SD-AT50 - Manual (Page 23)

E-18
SD-AT50(U)E2.fm 02/7/19
SD-AT50
ENGLISH
7
DX-AT50
Prepar
ation for
Use
- Gener
a
l c
o
ntr
ol
-
General control
" Connecting the AC power cord
Subwoofer/amplifier unit
After checking all the connections, connect the AC power cord to the AC power input
jack, then the subwoofer/amplifier unit into the AC outlet.
DVD Player
After checking all the connections, plug the DVD player into the AC outlet.
Notes:
! The power is supplied to the AV control unit by the subwoofer/amplifier unit. The
AV control unit is not equipped with a power cord.
! Never use a power cord other than the one supplied. Otherwise, a malfunction or
an accident may occur.
! Unplug the DVD player and the subwoofer/amplifier unit if they will not be used for
a prolonged period of time.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO
WIDE SLOT, FULLY INSERT.
" To turn the power on
Press the ON/STAND-BY button.
The power indicator lights up.
If the power does not turn on, check if the power cord is plugged in properly.
Note:
When the ON/STAND-BY button on the remote control is pressed, the power on both
units turns on.
" Volume control
Press the VOLUME + button to increase the volume and the VOLUME - button for
decreasing.
" To change the display brightness (2 levels)
You can switch the display brightness by holding down the DISPLAY button on the
remote control for 2 seconds or more.
Caution:
The display brightness depends on the setting of "PANEL DISPLAY" of "Changing
the initial setting of DVD". (See page 20.)
AC outlet
(AC 120 V, 60 Hz) (AC INPUT)
Prise murale
(120 V CA, 60Hz)
Dimmed Brightened
Power indicator
0 1 2 39 40
.....
[Front]