Sharp SD-AT50 - Manual (Page 17)

E-12
SD-AT50(U)E2.fm 02/7/19
SD-AT50
ENGLISH
7
DX-AT50
Prepar
ation for
Use
- S
y
stem connec
ti
o
n
s
-
All satellite speakers provide the same performance.
Their positions can be exchanged with one another.
" Connecting the satellite speakers
Insert the speaker plugs to the subwoofer/amplifier unit according to the color coding.
Connect the speaker cords to the satellite speakers first and then to the subwoofer/
amplifier unit.
Caution:
! Make sure to connect the speakers after unplugging the DVD player and the
subwoofer/amplifier unit.
! Insert the speaker plug fully with the rising side facing to the left.
! Hold the speaker plug when removing it from the subwoofer/amplifier unit. Pulling
the cord may cause malfunction to the subwoofer/amplifier unit.
! Do not mistake the and , and right and left terminals of the speaker cords. (The
right speaker is placed on the right when you face the system. See page 16.)
! Only the supplied speakers should be used with this product.
! Do not stand or sit on the speakers. You may be injured.
Binding cords:
Tie the cords connected to the subwoofer/amplifier unit with a cord holder.
Red Red Red
Red
Red Red
Red
Gray
Gray
Black Black
Black Black Black
Green
Green
Blue
Blue
White
White
Front speaker
(Right)
Surround speaker
(Right) Surround speaker
(Left)
Center speaker
Subwoofer/
Amplifier unit
Front speaker
(Left)
! Never short-circuit the speaker cords. If the
speaker cords are short-circuited, the protec-
tion circuit is activated and the power is turned
off. In such a case, check that the cords are
properly connected before turning the power
on again.
Tube
Red
Black
Label Speaker terminals
(Satellite speaker) (Subwoofer/amplifier unit)
Speaker Plug
Plug in with the rising
side facing to the left.
Cord holder