Southbend 436D - Manual (Page 55)

M ODEL 400 R ESTAURANT R ANGES
P
ARTS
O PERATOR ’ S M ANUAL 1182299 REV 3 (05/05) D RAFT P AGE 55 OF 64
PARTS
24", 36" and 48” Griddle Parts
See drawing on following page.
Key Part Number Description
1 1178204 Knob Control (Black knob with white arrow) (for ranges built before August 19, 2002)
1184689 Knob Control (Black knob with red stripe) (for ranges built after August 19, 2002)
2 1178202 Gas Valve, Hi-Off
3 1042980 Griddle Bar Burner
4 1134810 Burner Support (for ranges built before April 9, 2001)
1182285 Burner Support (for ranges built after April 8, 2001)
5 1181111 Griddle Assembly, 24", Left
1181108 Griddle Assembly, 24", Right
1181115 Griddle Assembly, 24", Left, Thermostatic
1181113 Griddle Assembly, 24", Right, Thermostatic
1181112 Griddle Assembly, 36", Left
1181107 Griddle Assembly, 36", Right
1181116 Griddle Assembly, 36", Left, Thermostatic
1181114 Griddle Assembly, 36", Right, Thermostatic
1187336 Griddle Assembly, 48", Left
1187337 Griddle Assembly, 48", Right
1187338 Griddle Assembly, 48", Left, Thermostatic
1187339 Griddle Assembly, 48", Right, Thermostatic
6 1162828 Griddle Pilot – Pipe Assembly(for 24" griddle)
1162980 Griddle Pilot – Pipe Assembly (for 36" griddle)
1187342 Griddle Pilot – Pipe Assembly for 460-4 (48" griddle, left and right)
1187397 Griddle Pilot – Pipe Assembly for 448-4 (48" griddle)
1187403 Griddle Pilot – Pipe Assembly for 448-3 (36" griddle, left and right)
7 1146906 90° Elbow
8 P3875 1/8 x 1/4 Straight Fitting
9 1099111 1/4 cc Nut
10 1162236 Pilot Tube
11 1099111 1/4 cc Nut
12 1099112 1/4 Ferrule
13 1163844 Pilot Adj. Valve
14 1179997 Thermostat Knob **
15 1174709 Thermostat Only **
16 1147201 Brass Tee **
17 1174713 Gas Supply Tube **
18 1008748 Orifice NAT **
1008755 Orifice LP **
19 1166150 Brass Elbow **
20 1174714 Gas Supply Tube **
* 1008748 Griddle Orifice NAT
* 1008756 Griddle Orifice LP
* 1181221 Grease Drawer (for ranges built before October 15, 2003)
1186275 Grease Drawer (for ranges built after October 15, 2003)
* not shown on drawing.
** used only on thermostatically controlled griddles (indicated by a “T” prefix)