Sanyo PLC-XP100BKL - Manual (Page 74)

74
Optional Parts
Lens Replacement
The lens of this projector can be replaced with other optional lens. This feature enables you to use the projector
for wide variety of uses.
For installation and replacement of the lens, always contact the sales dealer. The projector lens must be
installed or replaced by well-trained sales or service engineers. Do not attempt to install and replace the lens by
yourself as it may cause injury.
Do not hold the lens when carrying or lifting the projector. It may cause serious damage to the projector.
This projector is compliant with PJLink Standard Class 1 of JBMIA (Japan Business Machine and Information
System Industries Association). The projector supports all commands defined by PJLink Class 1 and is verified
conformance with PJLink Standard Class 1.
PJLink is a registered trademark of JBMIA and pending trademark in some countries.
PJ Link Notice
To the sales and service engineers:
For the lens replacement and lens installation, refer to the installation manual of the optional lens. Before replacing and
installing the lens, make sure that you are using the lens with the correct Type No.
Projector Input PJLink Input Parameter
Input 1 RGB (PC analog) RGB 1 11
RGB (Scart) RGB 2 12
RGB (PC digital) DIGITAL 1 31
RGB (AV HDCP) DIGITAL 2 32
Input 2 Video VIDEO 1 21
Y, Pb/Cb,Pr/Cr VIDEO 2 22
RGB RGB 3 13
Input 3 Video VIDEO 3 23
Y, Pb/Cb,Pr/Cr VIDEO 4 24
S-video VIDEO 5 25
Input 4 Network NETWORK 1 51
Model No.
Standard Zoom Lens : LNS-S30
Long Zoom Lens : LNS-T31A
Ultra Long Zoom Lens : LNS-T32
Short Zoom Lens : LNS-W31A
Short Fixed Lens : LNS-W32
COMPONENT-VGA Cable : POA-CA-COMPVGA
Remote Control Cable : POA-CA-RC30
PJ-Net Organizer Plus II : POA-PN03
PJ-Net Organizer Plus IIC : POA-PN03C
The parts listed below are optionally available. When ordering those parts, specify the item name and Model No.
to the sales dealer.
Appendix