Sanyo PLC-XP100BKL - Manual (Page 24)

4
Press the ON/STAND-BY button on the side control
or the STAND-BY button on the remote control, and
“Power off?” appears on the screen.
Press the ON/STAND-BY button on the side control or
the STAND-BY button on the remote control again to
turn off the projector. The LAMP indicator lights bright
and the POWER indicator turns off. After the projector
is turned off, the cooling fans operate for 90 seconds.
You cannot turn on the projector during this cooling
down period.
1
2
TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU
TURN THE PROJECTOR ON, WAIT AT LEAST FIVE
MINUTES BEFORE TURNING IT OFF.
DO NOT UNPLUG THE AC POWER CORD WHILE
COOLING FANS ARE RUNNING OR BEFORE THE
POWER INDICATOR LIGHTS GREEN AGAIN.
OTHERWISE IT WILL RESULT IN SHORTENING OF
THE LAMP LIFE.
3 When the projector has cooled down enough, the
POWER indicator lights green and then you can turn on
the projector. To unplug the AC power cord, wait until
the projector is completely cooled down.
“Power off?” disappears after 4 seconds.
✔ Note:
• When the On start function is set to “On,” the projector will be
turned on automatically by connecting the AC power cord to an AC
outlet (p.52).
• The running speed of cooling fans is changed according to the
temperature inside the projector.
• Do not put the projector in a case before the projector is cooled
enough.
• If the WARNING TEMP. indicator blinks red, see “Warning
Indicators” on page 63.
• The projector cannot be turned on during the cooling period with
the POWER indicator turned off. You can turn it on again after the
POWER indicator becomes green again.
Turning Off the Projector
DO NOT OPERATE THE PROJECTOR CONTINUOUSLY
WITHOUT REST. CONTINUOUS USE MAY RESULT
IN SHORTENING THE LAMP LIFE. TURN OFF THE
PROJECTOR AND LET STAND FOR ABOUT AN HOUR
IN EVERY 24 HOURS.
Basic Operation