Sanyo POA-LN01 - Manual (Page 14)

Configure the network with the computer
This example explains how to set the following configuration.
The default network configuration is set as follows.
Make sure that the monitor is connected to the network and then connect the AC cord to
the outlet.
1
Temporarily* 1 set up your computer network configuration to the same IP network num-
ber as the PJ-Net Organizer. For example, change your computer network configura-
tion as follows and restart the computer.
The network configuration of computer differs depending on each network environment or
your computer. For further information, please see the chapter “Configure the network of
computer” on page 17.
14
Installation
IP Address : 172.21.95.224
Subnet Mask : 255.255.255.0
Default Gateway : 172.21.95.1
DNS : 172.21.1.53
IP Address : 192.168.0.2
Subnet Mask : 255.255.255.0
Default Gateway : 0.0.0.0
DNS : 0.0.0.0
IP Address : 192.168.0.5
Subnet Mask : 255.255.255.0
Default Gateway : (blank)
DNS : (blank)
*1 Change your computerʼs network configuration temporarily. After completing the set up for the mon-
itor, you must set up again to the original network configuration for your computer. It is recommend-
ed to make a note of those network settings.