Sanyo POA-LN01 - Manual (Page 12)

[2] Connection of LAN cable
To connect to the network, it is required to use the UTP (Unshielded Twisted Pair) straight
cable with RJ-45 plug. There are two different types of cables depending on whether the
network is constructed with 10Base-T or 100Base-TX. Prepare the Hub (10Base-T or
100Base-TX) to distribute the network cable.
1
Disconnect the AC plug from the monitor.
2
Connect the UTP straight cable to the LAN port on the network board.
3
Connect the UTP straight cable to the hub.
12
Installation
✐
The AC cord must be disconnected from AC power outlet when connecting the cable. It may dam-
age the product.
✐ Use the UTP cross cable when you connect the computer and monitor directly not using the hub.
✐ When you connect the monitor into the 10Base-T network, use cable with category 3 or 5. When
you connect the monitor into the 100Base-TX network, use cable with category 5.
✐
The length of cable between hub and monitor should be less than 100m.