Stop bit select, Ascii format, Stop bit select -91 ascii format -91 – Symbol Technologies LS 400XI User Manual
Page 124
5-91
Parameter Menus
Stop Bit Select
The stop bit(s) at the end of each transmitted character marks the end of transmission of one
character and prepares the receiving device for the next character in the serial data stream.
The number of stop bits selected (one or two) depends on the number the receiving terminal
is programmed to accommodate. Set the number of stop bits to match host device
requirements.
1 STOP BIT
2 STOP BITS
ASCII Format
This parameter allows the scanner to interface with devices requiring a 7-bit or 8-bit ASCII
protocol.
7-BIT
8-BIT