Spectra Logic 10000 User Manual
Spectra Logic Tools
Table of contents
Document Outline
- Notices
- License Agreement
- Spectra Logic Contact Information
- Warnings and Cautions
- Contents
- 1 Introduction
- 2 Preparing the Host System
- 3 Preparing the Library
- Unpacking the Library
- Selecting an Appropriate Environment for the Library
- Preparing to Connect the Library
- Selecting the Mode of Library Operation
- Split-Bus Configuration
- Setting SCSI IDs
- Setting the Library Configuration Switch
- Connecting the SCSI Cables and Terminators
- Connecting the Serial Cable
- Connecting the Library to Fibre Channel
- Connecting the AC Power
- 4 Configuring the Library
- 5 Operating the Library
- 6 Maintaining the Library
- 7 Troubleshooting
- Library Operation Problems
- Library hangs, will not boot, or does not communicate with host
- Library boots, but will not come to Unit Ready state
- Library powers up with drive faults
- Library powers up with screen blank
- Library screens are locked
- Library screen does not respond to touch
- Drive fault displayed
- Drive alert displayed
- System fault displayed
- Library does not respond to move commands
- Power is lost during firmware upgrade, and upgrade process will not restart
- Tape Drive Problems
- Bar Code Problems
- Library Operation Problems
- 8 Technical Support and Service
- Important Information
- Spectra Logic Repair Policy
- Advanced Technical Support Options
- Contacting Technical Support
- Professional Services
- Library Specifications
- Sony AIT Tape Drive Specifications
- Sony AIT Media Specifications
- Bar Code Specifications
- The SCSI Bus
- SCSI Cables and Terminators
- Safety Agency Standards
- FCC Notice
- Japan
- BMPT Vfg 243/1991
- EU Declaration of Conformity
- Index