Sony CMT-GP8D - Manual (Page 39)

O
p
ti
onal
Comp
onen
ts
39 GB
1
Connect a digital optical cord.
See “Hooking up optional components” on
page 37.
2
Connect 6 speakers to an AV amplifier
equipped with a decoder.
For the speaker placement, refer to the
operating instructions supplied with the
connected amplifier.
3
Press DVD SETUP in stop mode.
The Setup Display appears.
4
Press < or , repeatedly to select
“AV”, then press ENTER.
5
Press M or m repeatedly to select
“Dolby Digital” or “DTS”, then press
ENTER.
6
Press M or m repeatedly to select “Bit
Stream”, then press ENTER.
7
Press DVD SETUP to turn off the Setup
Display.
8
Switch the output to 5.1 channel Dolby
Digital sound or 5.1 channel DTS
sound.
See “Changing the sound/subtitle/angle” on
page 18.
Note
If “Dolby Digital” or “DTS” is set to “Bit Stream”,
sound is not output from the supplied speakers and
optional headphone does not function.
1
Connect audio cords.
See “Hooking up optional components” on
page 37.
2
Start recording manually.
See “Recording on a tape manually” on
page 29.
Making a digital recording on
an MD
1
Connect a digital optical cord.
See “Hooking up optional components” on
page 37.
2
Press DVD N (or DVD NX on the
unit) to switch the function to DVD.
3
Press x twice to stop playback.
4
Start recording with the connected
digital component (MD deck, etc.)
Refer to the operating instructions provided
with the connected component.
5
Press DVD N (or DVD NX on the
unit) to start playing.
Notes
• You cannot make a digital recording in the following
cases.
– Copy guarded DVDs
– DVD Dolby Digital or DTS bit stream output
– CD-Rs/CD-RWs* recorded in music CD format
• You cannot make a recording when “Dolby Digital”
or “DTS” under “AV” is set to “Bit Stream”. Set
“Dolby Digital” and “DTS” to “PCM”.
* Playback is possible on a connected digital
component.
Enjoying the 5.1 channel
sound with the optional
amplifier Recording audio from a
connected component
Recording on a connected
component