Sagem F@ST 1500WG - Manual (Page 26)

3 - Configuring Client Computer
SAGEM F@st™ 1500 Reference Manual - 288053220-03
Page 3-2
Reproduction and communication prohibited without the written permission of E E E E
After completing hardware setup by connecting all your network devices, you need to configure
your computer to connect to the SAGEM F@st
TM 1500 ADSL Router.
See:
PC
Windows 98/Me on sub-section 3.2.1
Windows NT 4.0 on sub-section 3.2.2
Windows 2000 on sub-section 3.2.3
Windows XP sub-section 3.2.4
Mac
Mac OS 10.2 on sub-section 3.3
Configuring Your Macintosh Computer” depending on your operating system.
3.1 TCP/IP Configuration
To access the Internet through the SAGEM F@st TM 1500 ADSL Router, you must configure the
network settings of the computers on your LAN to use the same IP subnet as the
SAGEM F@st
TM 1500 ADSL Router. The default IP settings for the SAGEM F@st TM 1500 ADSL
Router are:
IP Address : 192.168.2.1
Subnet Mask : 255.255.255.0
These settings can be changed to fit your network requirements, but you must first
configure at least one computer to access the SAGEM F@st
TM 1500 ADSL
Router’s web configuration interface in order to make the required changes. (See
“Configuring the SAGEM F@st
TM 1500 ADSL Router” on chapter 4 for instruction
on configuring the SAGEM F@st TM 1500 ADSL Router).