Sagem F@ST 1500WG - Manual (Page 130)

Appendix E - Default configuration
SAGEM F@st™ 1500 Reference Manual - 288053220-03
Page E-2
Reproduction and communication prohibited without the written permission of E E E E
This section gives the default factory settings for the SAGEM F@st™ 1500. The
SAGEM F@st™ 1500 is set to "Router" mode by default.
These default settings can be modified by a special pre-configuration of the
SAGEM F@st™ 1500.
E.1 Default user name and password
Password Empty
E.2 Default configuration on the local area network side
LAN characteristics Function - Mode State/Value
IP characteristics IP address 192.168.2.1
Mask 255.255.255.0
BROADCAST, ARP, MULTICAST Enabled
IP - SERVICES RIP Disabled
DHCP server activated on the LAN 192.168.2.2 to 192.168.2.254
SSID broadcasting Enabled
ESSID "SAGEM"
Channel 6 (when channels 1 to 13)
10 (when channels 10 to 13)
WEP Enabled
"Wireless" characteristics
Only
SAGEM F@st
TM 1500WG
Keys 64 bits / Hex / Key1
(01/01/01/01/01)
E.3 Default configuration on the wide area network side
WAN characteristics Function - Mode State/Value
ATM characteristics Protocol IP/PPP/ATM
VPI 8
VCI 35
Encapsulation VC MUX
CLASS Traffic-type CBR
PCR 800 000 bit/s
NAT Enabled
Default route ADSL interface address
DNS relay Enabled
Firewall Enabled
Intrusion detection Disabled
OAM F4 and F5 (see Note) Enabled