4 powering up the sagem f@st™ 1500 adsl router, 2 - description and physical installation – Sagem F@ST 1500WG User Manual
Page 23
2 - Description and physical installation
SAGEM F@st™ 1500 Reference Manual - 288053220-03
Page 2-11
Reproduction and communication prohibited without the written permission of
E
E
E
E
2.4 Powering up the SAGEM F@st™ 1500 ADSL router
¾
Check that the SAGEM F@st™ 1500 router is connected correctly to the electrical power
supply network (see section 2.3.2).
¾
Set
the
I/O switch to I (bottom position).
Initially, the PWR LED and all the ETHERNET LEDs will come on. After a certain period, only
the PWR LED will remain lit, the extreme right ETHERNET LED is slowly blinking, the ALM LED
will come on and the WLAN LED (only for the SAGEM F@st™ 1500WG) will then come on if
the wireless module is installed and active, and finally the ADSL LED will start blinking.