JVC GR-DVL25 - Manual (Page 33)

EN
33
PLA
YBACK
1
Make sure all units are turned off.
2
Connect the camcorder to a TV or VCR as
shown in the illustration (
੬
pg. 32).
If using a VCR . . . go to step 3.
If not . . . go to step 4.
3 Connect the VCR output to the TV input,
referring to your VCR’s instruction manual.
4
Turn on the camcorder, the VCR and the TV.
5
Set the VCR to its AUX input mode, and set the
TV to its VIDEO mode.
To choose whether or not the following displays
appear on the connected TV . . .
•Date/Time
.... set “DISPLAY” to “ON” or “OFF” in the
Playback Menu (
੬
pg. 30).
•Time Code
.... set “TIME CODE” to “ON” or “OFF” in the
Playback Menu (
੬
pg. 30).
•Playback Sound Mode Display
.... set the Power Switch to “ ”. Press MENU/
BRIGHT and set “ON SCREEN” in the Date/
Time Menu (
੬
pg. 18 – 20) to “ON” or
“OFF”. Then, set the Power Switch back to
“
”.
NOTES:
● It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery
pack (
੬
pg. 7).
● To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder’s Power Switch to “
” or “ ”, then
set your TV to the appropriate input mode.
● Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
● If you have a TV or speakers that are not specially
shielded, do not place the speakers adjacent to the
TV as interference will occur in the camcorder
playback picture.