JVC LVT1321-010C - Manual (Page 9)

7
110V
127V
220V
230 -
240V
ı О ‰ П М З
Е
DVR
OUT(REC)
DVR/DVD
IN(PLAY)
Y
P B
P R
COMPONENT VIDEO
MONITOR
OUT
DVR/DVD
IN
VCR(DBS)
IN
DVR
OUT(REC)
DVR/DVD
IN(PLAY)
FRONT
This receiver is equipped with the following video terminals—
composite video, S-video, and component video terminals.
• If your video components have S-video (Y/C-separation) and/or
component video (Y, P B , P R ) jacks, connect them using an S-
video cable (not supplied) or component video cable (not
supplied). By using these terminals, you can get a better picture
quality in the order:
Component > S-video > Composite
IMPORTANT:
This receiver can convert composite video signals into S-video
signals.
When converting video signals, there are some points to observe.
For details, see “About video signal conversion” on page 11.
Connecting video components
Do not connect the AC power plug to the wall outlet until all connections are completed.
NOTES
• When connecting a DVD recorder or DVD player to the component video
input jacks, select the component video input mode (DVD VIDEO IN)
correctly. If you do not, you cannot view the playback picture on the TV or
the AV COMPU LINK remote control system cannot operate properly. See
page 22 for details.
• Select the analog input mode. See “Selecting the analog or digital input
mode” on page 14.
• You can enjoy digital sound if using a digital coaxial or optical cable.
When shipped from the factory, the audio input mode for a DVD recorder
and DVD player is set to use the digital coaxial terminal (DIGITAL IN 1
(DVR/DVD)). For details of digital connection, see page 11.
Turn off all components before making connections.
• When you connect other components, refer also to their
manuals.
DO NOT use a TV through a VCR or a TV with a built-in
VCR; otherwise, the picture may be distorted.
CAUTION:
If you connect a sound-enhancing device such as a graphic
equalizer between the source components and this receiver, the
sound output through this receiver may be distorted.
If your video components have AV COMPU LINK terminal
See also page 34 for detailed information about the connection
and the AV COMPU LINK remote control system.
Å To component video output
• Connect Y, P B , and P R correctly.
ı To left/right audio channel output
Ç Only for DVD recorder: To left/right audio
channel input
Î To composite video output
‰ To S-video output
Ï Only for DVD recorder: To S-video input
Ì Only for DVD recorder: To composite video
input
7 Connecting a DVD recorder or DVD player with its stereo output jacks:
White
Red
DVD recorder or
DVD player
White
Red
Stereo audio cable
(not supplied)
Green
Blue
Red
Component video cable (not supplied)
S-video cable (not supplied)
Composite video cable
(not supplied)
Composite video cable (not supplied)
06-07RX-D301S[UJ]_f.p65 05.6.13, 5:27 PM 7