JVC LVT1321-010C - Manual (Page 8)

6
L R
LS RS
SBL
C
SW
SBR (*SB)
LEFT RIGHT LEFT RIGHT LEFT RIGHT
SUBWOOFER
OUT
SURROUND
SPEAKERS
CAUTION:SPEAKER
IMPEDANCE 6 -16
SURROUND BACK
SPEAKERS
CENTER
SPEAKER
FRONT
SPEAKERS
110V
127V
220V
230 -
240V
Connecting the speakers
Do not connect the AC power plug to the wall outlet until all connections are completed.
Speaker Layout Diagram
CAUTIONS:
• Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals (6 Ω – 16 Ω).
• DO NOT connect more than one speaker to one speaker
terminal.
Connecting the speakers
Turn off all components before making connections.
Connecting the center speaker and the front speakers
1
Twist and remove the insulation at the end of each
speaker cord.
2
Turn the knob counterclockwise.
3
Insert the speaker cord.
• For each speaker, connect the (+) and (–) terminals on the
rear panel to the (+) and (–) terminals marked on the
speakers.
4
Turn the knob clockwise.
Connecting the surround speakers and the surround back
speakers
1
Twist and remove the insulation at the end of each
speaker cord.
2
Open the terminal (1), then insert the speaker cord
(2).
• For each speaker, connect the (+) and (–) terminals on the
rear panel to the (+) and (–) terminals marked on the
speakers.
3
Close the terminal.
*When using a single speaker for the surround back speaker
You can enjoy the surround sound by one surround back
speaker. When using one surround back speaker,
– set “SB OUT” to “
<
1SPK
>
” (see page 19) and
– connect the surround back speaker to the left surround back
speaker terminal. (No sound comes from the speaker if
you connect it to the right surround back speaker
terminal.)
Connecting the powered subwoofer
By connecting a subwoofer, you can enhance the bass or
reproduce the original LFE signals recorded in digital software.
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cord
with RCA pin plugs (not supplied).
• Refer also to the manual supplied with your subwoofer.
After connecting all the speakers and/or a subwoofer, set the
speaker setting information properly to obtain the best possible
surround effect. For details, see pages 17 to 21.
NOTE
You can place a subwoofer wherever you like since bass sound is
non-directional. Normally place it in front of you.
Center
speaker (C)
*Left surround
back speaker
(SBL)
Right surround
speaker (RS)
Left surround
speaker (LS)
Left front
speaker
(L)
Right front
speaker
(R)
Powered
subwoofer
(SW)
Right surround
back speaker
(SBR)
1 3 2 4
1 2 3
+
–
1
2
+
–
06-07RX-D301S[UJ]_f.p65 05.5.25, 4:49 PM 6