Operating other jvc products, 7 tv, 7 vcr – JVC LVT1321-010C User Manual
Page 38
36
You can use the supplied remote control to operate not only
this receiver but also other JVC products.
• Refer also to the manuals supplied with the other products.
– Some JVC VCRs can accept two types of the control
signals—remote codes “A” and “B.” This remote control can
operate a VCR whose remote control code is set to “A.”
– Some JVC DVD recorders can accept four types of the control
signals. This remote control can operate a DVD recorder
whose remote control code is set to the initial code. For
details, refer to the manual supplied with the DVD recorder.
• To operate other products, aim the remote control directly at the
remote sensor on the target product.
7 TV
Operating other
JVC products
You can always perform the following operations:
TV
:
Turn on or off the TV.
TV VOL +/–:
Adjust the volume on the TV.
TV/VIDEO:
Change the input mode (either video
input or TV tuner) on the TV.
After pressing TV, you can perform the following operations on the
TV.
CHANNEL +/–:
Change the channel numbers.
1 – 9, 0, 100+ (+10):
Select the channel numbers.
RETURN (10):
Switch between the previous channel
and the current channel.
7 VCR
You can always perform the following operation:
VCR
:
Turn on or off the VCR.
After pressing VCR, you can perform the following operations on
the VCR.
CHANNEL +/–:
Change the channel numbers on the
VCR.
1 – 9, 0:
Select the channel numbers on the
VCR.
3:
Start playback.
7:
Stop playback.
8:
Pause playback. To release it, press
3.
FF:
Fast-wind a tape.
REW:
Rewind a tape.
REC PAUSE:
Enter recording pause. To start
recording, press this button then
3.
1
2
3
4
5
6
7
8
9
10
0
10
1
2
3
4
5
6
7
8
9
10
0
10
36-40RX-D301S[UJ]_f.p65
05.5.25, 5:38 PM
36