JVC AV 61S902 - Manual (Page 44)

44
Initial Setup
INITIAL SETUP
TV SPEAKER
SUPER BASS MID LOW
OFF
NEXT PAGE
PREVIOUS
OPERATE BY
EXIT BY SELECT
EXIT
HIGH
ON
BY
INITIAL SETUP Menu
Access the onscreen menus by pressing M ENU on your remote control. You may then either use the up and
down arrows
5∞ to scroll to the INITIAL SETUP menu, or press M
ENU until the INITIAL SETUP screen
appears. Use the
5∞ arrows to move to the setting you wish to change. You can make adjustments to any or
all of the settings.
SUPER BASS HIGH MID LOW
The SUPER BASS function dramatically adjust the bass sound of the television. SUPER BASS has three set-
tings:
HIGH - The bass is emphasized to give a heavy, booming sound
MID - The bass is treated normally, bass levels are in the same range as high and mid frequencies
LOW - The bass is softened, low end sounds are made weaker
Use the
5∞ arrows to select the SUPER BASS function. Use the
2
or
3
arrows to select HIGH, MID, or
LOW. Once you have made your selection, press E XIT to return to normal television viewing.
ON TV SPEAKER OFF
The TV SPEAKER option turns the television’s internal speakers on or off. The television comes from the facto-
ry with the internal speakers turned on. If you connect your television to a home stereo system, use this option
to turn the TV’s speakers off. To turn the speakers off press
2
or
3
to highlight OFF. Press
5∞ to enter your
selection. If you later disconnect from the home stereo, use this option to turn the TV’s speakers back on.
• Before you turn the TV SPEAKER setting from OFF to ON, make sure that the TV volume is set very low!
If the TV volume is set too high when the speakers are turned on, the sound level may be extremely loud
and could damage the speakers.
• The TV SPEAKER option can not be operated from the menu screen when DOLBY PRO LOGIC is selected
on the SOUND MODE menu.
Note: When using external speakers, make sure you shut off the television’s speakers by using the TV SPEAKER option
shown above.