Jensen UV9 - Manual (Page 6)

2
UV9
Optional Equipment
• NAV101/NAV102
The UV9 is "navigation ready." Before accessing any
navigation features, you must purchase and install the
avigation module (NAV101 or NAV102). All installation
and operating instructions will be included with the
navigation module.
Once the navigation module is connected and operating
properly, the NAV source mode will become active.
While the navigation module is not installed, the NAV
option appears gray, indicating the function is not
available.
• Rear Camera
The UV9 is "camera ready." Before accessing any
camera features, you must purchase and install a rear
video camera. Once the rear camera is connected and
operating properly, the CAMERA source mode will
become active. While the camera is not installed, the
CAMERA option appears gray, indicating the function is
not available.
What’s in the Box
1. UV9 Head Unit
2. Single DIN sleeve
3. Wiring harness
4. Parking brake sensor extension wire
5. Mounting hardware
6. Cosmetic trim ring
7. Remote Control
8. Owners Manual
9. Quick Start Guide
Tools and Supplies
You will need these tools and supplies to install your UV9:
• Torx type, flat-head and Philips screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio (screwdriver, socket
wrench set or other tools)
• Electrical tape
• Crimping tool
• Volt meter/test light
• Crimp connections
• 18 gauge wire for power connections
• 16 – 18 gauge speaker wire
WARNING! Only connect the unit to a12-volt power
supply with proper grounding.
WARNING! Never install this unit where operation and
viewing could interfere with safe driving conditions.
WARNING! To reduce the risk of a traffic accident (except
when using for rear view video camera) never use the
video display function while driving the vehicle. This is a
violation of federal law.
WARNING! Never disassemble or adjust the unit.
WARNING! To prevent injury from shock or fire, never
expose this unit to moisture or water.
WARNING! Never use irregular discs.
WARNING! To prevent damage to the mechanism inside
this unit, avoid impact to the TFT monitor.
WARNING! Using an improper fuse may cause damage
to the unit and result in a fire.
WARNING! The monitor employs an automatic motorized
mechanism. To prevent damage to the core mechanism,
please do not push, pull or swivel the monitor manually.
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and
remove the negative (-) battery cable prior to installation.
NOTE: If the UV9 is to be installed in a car equipped with
an on-board drive or navigation computer, do not
disconnect the battery cable. If the cable is
disconnected, the computer memory may be lost. Under
these conditions, use extra caution during installation to
avoid causing a short circuit.