JAI AT-140GE - Manual (Page 29)

AT-140GE
- 27 -
9.2.5 Note for 100BASE-TX connection

In order to use 100Mbps network, 100BASE-TX and Full Duplex are available. Half
Duplex cannot be used.

In the case of connecting on 100BASE-TX, the maximum packet size should be 1500
bytes.

In the case the of connecting on 100BASE-TX, the specifications such as frame rate,
trigger interval and so on described in this manual cannot be satisfied.
Pixel Type Frame rate at Full Frame scan[fps]
RGB8_Packed Approx. 2
RGB10V1_Packed,RGB10V2_Packed Approx.1.5
Note: The above frame rates are based on approx. 70Mbps of total frame transfer data.
9.3. Basic Functions
9.3.1 Basic construction
The AT-140GE is a 3CCD camera equipped with F4, 1/2 inch prism optics. Red, green and blue
color signals are taken from each 1.45 mega CCD which are filtered to the red, green and
blue spectral wavelengths. A 32-bit microprocessor controls all functions in the AT-140GE
camera. The CCD sensor output is normalized in CDS and preamplifiers. The signals are then
digitized to 16 bits. Digital gain control, color matrix, look-up tables and setup can do signal
processing in 16 bits before the signal is converted to a 32- or 24-bit RGB pixel format via
GigE
Vision interface.
Fig.21 Principle diagram for signal processing
750 nm 700 650 600 550 50
0 450
4
0
0
Light
CCD
CCD
CCD
B ch
A/D & process circuit
Blemish compensation
Shading compensation
Color matrix
LUT/Gamma/Knee
G
ig
E
I
n
te
rfa
c
e
G ch
A/D & process circuit
Blemish compensation
Shading compensation
Color matrix
LUT/Gamma/Knee
R ch
A/D & process circuit
Blemish compensation
Shading compensation
Color matrix
LUT/Gamma/Knee
750 nm 700 650 600 550 50
0 450
4
0
0
750 nm 700 650 600 550 50
0 450
4
0
0