JBL DSC 800 - Manual (Page 16)

14
A N T E N N A C O N N E C T I O N S
Connect the supplied AM and FM
antennas as shown for radio
reception. Connect the AM loop antenna to the
AM screw terminals. Connect the FM antenna to the
75 Ohm FM antenna socket.
Notes:
• To prevent noise pickup, keep the
AM loop antenna away from the
system and other components.
• Be sure to fully extend the FM wire
antenna.
• After connecting the FM wire
antenna, keep it as horizontal as
possible. Move it until you receive
the best reception.
If you have poor FM reception
Use a 75-ohm coaxial cable (not
included) to connect the system to an
outdoor FM antenna as shown below
or to the radio antenna connector on
the wall for the roof antenna on your
house (if any).
Notes:
• If you connect the system to an
outdoor antenna, ground it against
lightning.
• To prevent a gas explosion, do not
connect the ground wire to a gas
pipe.
FM antenna
(included)
AM loop antenna
(included)
To ground
Ground wire
(not included)
Outdoor FM antenna