JVC GM-H40L2A User Manual

Page 15

ENGLISH

Note for VIDEO IN A (IN, Y/C IN) terminals

When both IN terminal and Y/C IN terminal are used, the input to the Y/C IN terminal has priority.

Note for VIDEO IN B (RGB/COMPO., DVI-D) terminals

Select the correct input for Input B on the main menu (see “INPUT CONFIGURATION” on page 23).
• When RGB signals are input to the RGB/COMPO. terminal: Set “INPUT B” to “ANALOG RGB.”
• When component signals are input to the RGB/COMPO. terminal: Set “INPUT B” to “COMPONENT.”
• When using the DVI-D terminal: Set “INPUT B” to “DVI.”

Note for component signals

• The monitor is compatible only with Y on sync signals. The monitor is not compatible with composite sync (Cs) and

separated sync (HD/VD) signals.

Note for computer signals

• When analog RGB signals are input, part of the picture may not be displayed or an unnecessary picture may appear in the

following cases. Adjust size and position in the “SIZE SETTING” menu (see page 21).
– When a signal other than those listed on page 12 is input
– When the horizontal/vertical frequency of the signal is different though its resolution is the same as that of the signals

listed on page 12

– When the resolution of the signal output from the personal computer is different from that set for the personal

computer’s display.

• Any signal other than those listed on page 12 may not be displayed normally although it’s frequency is within the

acceptable range.

• Depending on the connected equipment, the monitor may not be compatible with composite sync (Cs) or G on sync

signals.

• When a preset mode signal is input, the signal format is displayed on the screen. For other signals, the horizontal/vertical

frequency or resolution is displayed.

• The DVI-D terminal can accept only No. 3, 4, 6 – 11, 16, 18, and No. 19 signals.
• When the No. 3 and No. 7 signals are input, set the video card of the personal computer to “640 x 480” (for No. 3 signal)/

“1024 x 768” (for No. 7 signal). For analog RGB input, also set “SAMPLING MODE” to “STD” on the set-up menu (see page 31).

• When the No. 4 and No. 8 signals are input, set the video card of the personal computer to “852 x 480” (for No. 4

signal)/“1366 x 768” (for No. 8 signal). For analog RGB input, also set “SAMPLING MODE” to “WIDE” on the set-up menu (see
page 31), and then change the aspect ratio to “FULL” (see pages 17 and 21).

• When No. 15 to No. 20 and No. 24 signals are input, thin lines may become obscured because their signal frequencies are

higher than the screen resolution.

• When the No. 16 signal is input, set the video card of the personal computer to “1280 x 1024.” For analog RGB input, also set

“SXGA/SXGA+” to “SXGA” on the set-up menu (see page 31).

• When the No. 18 and No. 19 signals are input, set the video card of the personal computer to “1400 x 1050.” For analog RGB

input, also set “SXGA/SXGA+” to “SXGA+” on the set-up menu (see page 31).

06-42_GM-H40L2A-f.indd 13

06.4.24 5:20:14 PM