JVC HR-XV48EK - Manual (Page 64)

Filename [XV48EK_10Subsidiary.fm]
Masterpage:Left+
Page 64 November 18, 2004 10:44 pm
SUBSIDIARY SETTINGS (cont.)
64
Video Channel Set
Video channel (RF output channel) is the channel on which your
TV receives picture and sound signals from the unit through the
RF cable.
If you have connected the unit to your TV via the AV
connection (
੬
pg. 11), you have to set the video
channel to off.
If you have connected the unit to your TV via the RF
connection (
੬
pg. 11), you have to set the correct
video channel.
A
Access the Video Channel Set mode.
Hold down 8 on the unit until the front display panel
shows the following.
B
Set the video channel.
With AV Connection
Press PR – until the front display panel shows “– –.”
● Now the video channel is set to off.
With RF Connection
Press PR + or – to set the unit to a vacant channel
between 22 and 69 which is not occupied by any local
station in your area.
(Example) If channel 50 is available in your area
Then set your TV to UHF channel 50.
● If the two vertical white bars appear
clearly on the TV screen as shown to
the right, go to step
C.
● If the two vertical white bars do not
appear clearly, re-set the unit to
another vacant channel and try again.
NOTES:
● If you set the unit to a channel which is occupied by a local
station or has neighbouring channels that are occupied by
local stations, the picture reception quality will be affected
and some interference noise will appear on the TV screen. Be
sure to select a vacant channel which has no broadcast on
neighbouring channels.
● If you cannot obtain the two vertical white bars clearly with
any channel between 22 and 69, consult your JVC dealer.
C
Exit the Video Channel Set mode.
Press ENTER.
IMPORTANT
Perform the following steps only if —
— Video Channel Set has not been done correctly by the
Auto Set Up function (
੬
pg. 12),
— interference appears in the TV picture after you have
moved to a different area or a new station has started
broadcasting in your area.
— you change the connection between your unit and TV
from RF connection to AV connection, or vice versa.
Before performing the following steps:
● Make sure there is no cassette inserted in the unit.
● Press VCR/DVD on the unit or VCR on the remote control
so that the VCR indicator lights up, then press 1 to turn
off the unit.
With AV Connection
To view picture signals from the unit, set your TV to its
AV mode.
With RF Connection
The channel you have set in step
B is your video
channel.
To view picture signals from the unit, set your TV to
this video channel.
XV48EK_01.book Page 64 Thursday, November 18, 2004 10:45 PM