JVC HR-XV48EK - Manual (Page 26)

Filename [XV48EK_07S-VHS.fm]
Masterpage:Left+
Page 26 November 18, 2004 10:44 pm
OPERATIONS ON VHS DECK (cont.)
26
Express Timer
Programming
If you do not know the PlusCode number for the programme you
wish to record, use the following procedure to set your unit to
timer-record the programme.
Example: To timer-record the programme from 21:00 to
22:00 on 25th December, on channel 1.
A
Select the VHS deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the remote control
Press VCR so that the VCR indicator lights up.
B
Access the VIDEO Plus+ screen.
Press PROG.
C
Access the Programme screen.
D
Enter the programme start time.
E
Enter the programme stop time.
Press STOP +/– to enter the time you want recording to
stop.
● Press and hold STOP +/– to move in 30-minute increments, or
press and release repeatedly to move 1 minute at a time.
F
Enter the programme date.
Press DATE +/–.
● The current date appears on the TV screen. The date you enter
appears in its place.
G
Enter the channel position.
H
Set the tape speed.
Press p.
I
Set the PDC mode.
Press PDC (number key “7”) to select “ON” or “OFF.”
● If “VPS/PDC ON” is displayed on the TV screen, “PDC” is set
to “ON.”
● If “VPS/PDC OFF” is displayed on the TV screen, “PDC” is set
to “OFF.”
੬
“PDC Recording” on page 25.
● VPS (Video Programme System) recording is not currently
available in the U.K. and not possible with this unit.
J
Return to the normal screen.
Press PROG or ENTER. “PROGRAM COMPLETED”
appears on the TV screen for about 5 seconds, then the
normal screen appears.
● Repeat steps B – J for each additional programme.
K
Engage the unit’s timer mode.
Press #. The unit turns off automatically and “#”
appears on the front display panel.
● To disengage the timer mode, press # again.
Before performing Express Timer Programming:
● Make sure that the unit’s built-in clock is set properly.
● Insert a cassette with the safety tab in place. The unit will
come on automatically.
● Turn on the TV and select the video channel (or AV mode).
● Slide the TV/VCR/DVD switch on the remote control to the
right.
Press START +/–. (If you’re
just starting out, “P1”
appears.)
Slide to the
right.
Press START +/– to enter the
time you want recording to
start.
● Press and hold START +/– to
move in 30-minute
increments, or press and
release repeatedly to move 1
minute at a time.
Press PR +/–.
XV48EK_01.book Page 26 Thursday, November 18, 2004 10:45 PM