JVC HR-XV48EK - Manual (Page 54)

Filename [XV48EK_10Subsidiary.fm]
Masterpage:Left+
Page 54 November 18, 2004 10:44 pm
SUBSIDIARY SETTINGS (cont.)
54
8 POWER SAVE — ON / OFF
When this function is set to “ON,” you can reduce the power
consumption while the unit is turned off.
NOTES:
● During Power Save mode:
— the front display panel will be turned off.
— the Just Clock function (
੬
pg. 65) does not work.
— the picture may be distorted momentarily when you turn
on/off the unit.
● Power Save does not work when:
— the unit is in the timer mode.
— the unit’s power is turned off after timer-recording or Instant
Timer Recording.
— the Automatic Satellite Programme Recording mode is
engaged. (
੬
pg. 28)
— “L-2 SELECT” is set to “DECODER” or “SAT.”
8 VIDEO STABILIZER — ON / OFF
When this function is set to “ON,” you can automatically correct
vertical vibration in the picture when playing back unstable
recordings made on another recorder.
NOTES:
● When you finish viewing a tape, be sure to set this function to
“OFF.”
● Regardless of the setting, this function has no effect during
recording and during special effects playback.
● The on-screen display may jitter vertically when this function
is set to “ON.”
● To watch recordings with close-caption, set this function to
“OFF.”
8 L-2 SELECT — A/V / DECODER / SAT
Set “L-2 SELECT” to the appropriate mode depending on the
type of appliance connected to the unit’s L-2 IN/DECODER
connector.
A/V : To use this unit as the recording deck with the player
connected to the L-2 IN/DECODER connector, or to use the
satellite receiver connected to the L-2 IN/DECODER
connector.
DECODER : To use a decoder connected to the L-2 IN/DECODER
connector.
SAT : To view a satellite programme with the TV set while the
unit is turned off. (
੬
pg. 50)
NOTES:
● Decoder function is not available in the U.K.
● If you have a satellite receiver or a decoder connected to the
L-2 IN/DECODER connector, be sure to set “L-2 SELECT” back
to the appropriate mode after editing.
● If you are not connecting a satellite receiver or a decoder to the
L-2 IN/DECODER connector, leave “L-2 SELECT” set to “A/V.”
● When “L-2 SELECT” is set to “SAT,” “SAT” appears on the TV
screen or front display panel instead of “L-2.”
8 AUTO POWER OFF — 3H / OFF
When this function is set to “3H,” the unit is turned off
automatically if no operation is done within 3 hours. “AUTO
POWER OFF IN 3 MIN” appears on the screen 3 minutes before
the unit is turned off.
XV48EK_01.book Page 54 Thursday, November 18, 2004 10:45 PM