JVC HR-XV48EK - Manual (Page 37)

Masterpage:Right-No-Heading
37
Filename [XV48EK_08DVD.fm]
Page 37 18 November 2004 10:44 pm
Sound Effect
Using the Sound Effect function, you can change the sound field.
● This function works only for analog audio output.
A
Access the selection menu.
Press SOUND EFFECT during playback.
● The current setting appears on the TV screen.
B
Select the Sound Effect mode.
Press SOUND EFFECT repeatedly to select the desired
mode.
● Each time you press SOUND EFFECT, the Sound Effect mode
changes as follows:
SOUND EFFECT:1]SOUND EFFECT:2]
SOUND EFFECT:3]OFF](Back to the beginning)
● As the value becomes bigger, the Sound Effect works stronger.
● The selection menu disappears if no operation is done for
about several seconds.
To deactivate Sound Effect
Press SOUND EFFECT
repeatedly until “OFF” appears on
the TV screen.
VFP Function
— Adjusting the Picture Quality
The VFP (Video Fine Processor) function enables you to adjust
the picture character according to the type of programming,
picture tone or personal preference.
A
Access the VFP setting menu.
B
Select the VFP mode.
Press w e repeatedly.
● Each time you press w e, the VFP mode changes as follows:
NORMAL]CINEMA]USER 1]USER 2](Back to the
beginning)
To adjust picture appearance manually
C
Access the USER menu.
Press w e repeatedly to select “USER 1” or “USER 2.”
D
Select the parameter.
Press rt repeatedly to select a parameter you want to
adjust, then press ENTER.
● Adjust gradually and confirm picture appearance results are as
preferred.
● VFP menu disappears and the following pop-up window
appears on the TV screen.
E
Adjust the parameter.
Press rt repeatedly to change the setting, then press
ENTER.
● The current VFP settings appear again.
Repeat steps D and E to adjust other parameters.
To return to the normal screen
Press DVD PICTURE.
NOTE:
The VFP setting screen disappears if no operation is done for
more than about 10 seconds.
Press DVD PICTURE during
playback.
● The current setting appears on
the TV screen.
NORMAL : For watching TV in a general room.
CINEMA : For watching a movie software in a room
with suppressed light.
USER 1 /
USER 2 :
You can adjust parameters that affect the
picture appearance and store the settings. Go
to step
C
.
GAMMA
(LOW/MID/
HIGH):
Adjust this if the neutral color is bright or dark.
The brightness of dark and bright portions is
maintained.
BRIGHTNESS
(–16 to +16):
Adjust this if the picture is bright or dark on
the whole.
CONTRAST
(–12 to +12):
Adjust this if the objects in far and near
positions look unnatural.
SATURATION
(–16 to +16):
Adjust this if the picture is whitish or blackish.
TINT
(–16 to +16):
Adjust this if the appearance of flesh tone is
unnatural.
SHARPNESS
(LOW/ HIGH):
Adjust this if the picture is indistinct.
Y DELAY
(–2 to +2):
Adjust this if the picture looks separately or
overlapped.
XV48EK_01.book Page 37 Thursday, November 18, 2004 10:45 PM