JVC DLA-HD10KSU/E - Manual (Page 40)

40
What to do when these messages are displayed
Message Cause (Details)
No device is connected to the [DVI] terminal.
The DVI-D cable is connected to the [DVI] terminal but
there is no signal input.
NInput the video signals.
A video signal that cannot be used with this unit has
been input.
NInput 1080/50p or 1080/60p video signals.
Upon pressing the [ZOOM T/W] or [FOCUS +/ -] button
when AZoom/FocusB of the AOptionsB menu is set to
ALockB.
NSet AZoom/FocusB of the AOptionsB menu to
AUnlockB.
At the moment when the accumulated lamp time
reaches 1900 hours, a
ALamp replacementB message
will be displayed.
In addition, when the accumulated lamp time reaches
between 1900 hours to 2000 hours, the (Lamp
replacement) message will be displayed each time the
projector is turned on.
● The message can be cleared by pressing any button on
the remote control or this unit.
NGet ready a new lamp (lamp unit) in advance or
replace as soon as possible.
The ALamp replacementB message will be displayed
and the AWarningB word appears blinking when the
accumulated lamp time exceeds 2000 hours.
The message can be cleared by pressing the [EXIT]
button. However, the same message will reappear every
hour.
When the accumulated lamp time exceeds 2000 hours,
the unit cannot be turned on again once it is switched to
the standby mode or turned off.
If continuous projection is performed after 2000 hours,
the unit will shut down upon exceeding 2010 hours and
projection will be disabled.
NInstall a new lamp (lamp unit) and reset the lamp time.
( A Pages 35 - 38)
No Signal DVI-D
Out Of Range
not available
Lamp replacement
EXIT
Lamp replacement
EXIT
Warning
DLA-HD10_EN-FR.book Page 40 Thursday, November 10, 2005 12:54 PM