JVC DR-MX1S - Manual (Page 77)

Masterpage:Right+
EN
77
Filename [MX1SEU_12Editing.fm]
SYSTEM CONNECTIONS
Page 77 Monday, 6 December 2004 14:01
These instructions enable you to connect your unit to a Dolby
Digital Decoder or an amplifier with built-in DTS.
1
Connect the unit and a Dolby Digital Decoder or an amplifier
with built-in DTS using either an optional optical cable or an
optional coaxial cable.
NOTES:
● For Dolby Digital sound, set ADIGITAL AUDIO OUTB to ADOLBY
DIGITAL/PCM B. (A pg. 78)
● For DTS sound, set ADIGITAL AUDIO OUTB to ASTREAM/PCMB.
(A pg. 78)
CAUTIONS:
● This unit has a dynamic range of more than 110 dB with regards
to its Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to
the speakers may damage them.
● Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do
not place the speakers adjacent to the TV set as this can
adversely affect the playback picture.
When you can’t switch the audio channel of a bilingual
programme
When the unit is connected with a digital audio device using an
optional optical cable and
ADIGITAL AUDIO OUTB is set to
ADOLBY DIGITAL/PCMB, it is not possible to switch the audio
channel of a bilingual programme recorded on a DVD-RAM or
DVD-RW (VR mode) disc. In this case, perform the following steps
using the remote control to switch
ADIGITAL AUDIO OUTB from
ADOLBY DIGITAL/PCMB to APCM ONLYB.
A Press SET UP to access the Main Menu screen.
B Press
D E to select ADVD VIDEO SET UPB, then press G.
C Press D E to select AAUDIO OUTPUTB, then press G.
D Press F G to select ADIGITAL AUDIO OUTB, then press
ENTER.
E Press F G to select APCM ONLYB, then press ENTER.
(A pg. 78)
F Press SET UP to complete the setting.
G Press AUDIO to select the desired audio channel.
The [L-2 IN/DECODER] connector can be used as an input
connector for an external decoder (descrambler). Simply connect a
decoder and you can enjoy a variety of programming that is
available through scrambled channels.
1
Set AL-2 SELECTB to ADECODERB. (A pg. 72)
2
Connect your unit’s [L-2 IN/DECODER] connector to the
decoder’s 21-pin SCART connector using a 21-pin SCART
cable.
3
Perform the procedure as described in AWhen Receiving A
Scrambled Broadcast (HDD & DVD Deck Only) B (A pg. 85).
Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
Dolby Digital Decoder or
amplifier with built-in DTS
Coaxial cable
(not supplied)
Rear of unit
Note for connection:
Remove the protection cap from the optical cable.
To [DIGITAL AUDIO
OUT (COAXIAL)]
To DIGITAL AUDIO input
Optical cable
(not supplied)
To [DIGITAL AUDIO
OUT (OPTICAL)]
Connecting/Using A Decoder
(HDD & DVD Deck Only)
TV
RF cable (supplied)
TV aerial cable
[L-1 IN/OUT]
[L-2 IN/DECODER]
Decoder
MX1SEU_00.book Page 77 Monday, December 6, 2004 2:01 PM