Video recording & playback, Video recording, Basic recording – JVC GR-DV4000 User Manual
Page 17: Info lcd indications
EN
17
Master Page: Right-start
VIDEO
RECO
RD
ING
&
PLA
Y
B
A
CK
VIDEO RECORDING
NOTE:
Before continuing, perform the procedures listed
below:
● Loading A Cassette (੬ pg. 15)
1
Remove the lens cap.
2
Press PUSH OPEN and open the LCD monitor
fully, or pull out the viewfinder fully.
3
Set the VIDEO/MEMORY Switch to “VIDEO”.
4
Set the Power Switch to “A” or “M” while
pressing down the Lock Button located on the
switch.
● The power lamp lights and the camcorder
enters the Record-Standby mode. “PAUSE” is
displayed.
5
To start recording, press the Recording Start/Stop
Button. The tally lamp lights and “T REC”
appears on the display while recording is in
progress.
6
To stop recording, press the Recording Start/Stop
Button again. The camcorder re-enters the
Record-Standby mode.
NOTES:
● The image will not appear simultaneously on the
LCD monitor and the viewfinder.
● If the Record-Standby mode continues for
5 minutes, the camcorder’s power shuts off
automatically. To turn the camcorder on again,
push back and pull out the viewfinder again or
close and re-open the LCD monitor.
● LCD monitor/viewfinder indications:
• When power is supplied from a battery: the
“
” battery indicator is displayed. (
• When power is supplied from an AC outlet: the
“
” battery indicator does not appear.
● When a blank portion is left between recorded
scenes on the tape, the time code is interrupted
and errors may occur when editing the tape. To
avoid this, refer to “Recording From The Middle
Of A Tape” (
● To turn the tally lamp or beep sounds off,
● To record in LP (Long Play) mode, ੬ pg. 31, 34.
● For other notes, ੬ pg. 67.
INFO LCD Indications
a Tape indicator
(Appears when a cassette is loaded and blinks
when no cassette is loaded.)
b Recording time
c Battery indicator
● To turn off the indications, ੬ pg. 31, 38.
Basic Recording
Power Lamp
VIDEO/MEMORY Switch
Recording Start/Stop Button
Power Switch
Lock Button
Tally Lamp
(Lights while recording is in
progress.)
Power Zoom Lever
PUSH OPEN Button
INFO LCD
1
2
3
GR-DV4000PAL.book Page 17 Friday, February 14, 2003 10:30 PM