John Lewis JLDW 1225 - Manual (Page 8)

Delay start button
Press this button to delay the start of the
washing programme from 1 to 24 hours.
Refer to 'Select and start a washing
programme'.
Programme buttons
To select a washing programme, press one
of these buttons until the display shows the
programme number.
Energy save button
This function decreases the temperature in
the drying phase. The power consumption is
reduced by 25%.
Dishes can still be wet at the end of the
programme when you open the appliance
door. We recommend that you keep the
door ajar and let the dishes dry.
Press this button to switch on the option.
The related indicator comes on.
This function is available with all the washing
programmes but has no impact on some
programmes. Refer to ''Washing
programmes''.
Multi tab button
Allows the use of combi detergent tablets
(e.g. 3 in 1, 4 in 1, 5 in 1). Refer to ''Multi tab
function''.
Reset button
Press this button to cancel a washing
programme in progress.
Indicators
Salt 1) The indicator comes on when the
salt has run out.
The salt indicator can remain on
for a few hours after that salt has
been replenished (assuming the
appliance remains switched on).
The operation of the appliance is
not affected.
Rinse aid
1)
The indicator comes on when the
rinse aid has run out.
End The indicator comes on when the
washing programme ends.
1) The salt and rinse aid indicators are never on while a
washing programme is running even if filling with salt
and/or rinse aid is necessary.
Function buttons
The following operations can be done with
these buttons:
• The electronic setting of the water
softener.
• The cancellation of a washing programme
in progress.
• The activation or deactivation of the rinse
aid dispenser (only with the Multi tab
function activated).
• Activation or deactivation of the acoustic
signals.
Setting mode
The appliance must be in setting
mode for these operations:
• To start a washing programme.
• To start a delay start.
• To adjust electronically the level of the
water softener.
8