John Lewis JLDW 1225 - Manual (Page 25)

Malfunction Possible cause Possible solution
The mains plug is not
connected in the mains socket. Connect the mains plug.
The fuse in the fuse box is
damaged. Replace the fuse.
The delay start is set. • Cancel the delay start.
• When the countdown is
completed, the washing
programme starts
automatically.
Once the checks have been carried out,
switch on the appliance. The programme
continues from the point at which it was
interrupted. If the malfunction occurs again or the display
shows an alarm code that is not listed in the
table, please contact our extended warranty
administrators. Refer to 'Repairs - after sales
service'.
The washing and drying results are not satisfactory
The dishes are not clean.
The washing programme was
not applicable for the type of
load and soil. Make sure that the washing
programme is applicable for the
type of load and soil.
You did not put the items
correctly in the baskets, water
did not touch all surfaces. Put the items correctly in the
baskets.
The spray arms could not turn
freely. Incorrect position of the
items in the baskets. Make sure that an incorrect
position of the items do not
cause the blockage of the spray
arms.
The filters are dirty or not
assembled and installed
correctly. Make sure that the filters are
clean and correctly assembled
and installed.
The quantity of detergent was
not sufficient or missing. Make sure that the quantity of
detergent is sufficient.
Limescale particles on the
dishes. The salt container is empty. Fill the salt container with
dishwasher salt.
Incorrect level of the water
softener adjustment. Adjust the water softener with
the correct level.
The salt container cap is not
closed correctly. Make sure that the salt
container cap is closed
correctly.
25