John Lewis JLDW 1225 - Manual (Page 26)

The washing and drying results are not satisfactory
There are streaks, whitish
stains, or a bluish layer on
glasses and dishes.
The rinse aid quantity is too
high. Decrease the rinse aid quantity.
Dry water drop stains on
glasses and dishes. The rinse aid quantity is too
low. Increase the rinse aid quantity.
The detergent can be the
cause. Use a different brand of
detergent.
The dishes are wet. The washing programme was
without a drying phase or with
a decreased drying phase. For better drying results, keep
the door ajar for some minutes.
The dishes are wet and matt. The rinse aid dispenser is
empty. Fill the rinse aid dispenser with
rinse aid.
The Multi tab function is on
(this function automatically
deactivates the rinse aid
dispenser). Activate the rinse aid dispenser.
Activating the rinse aid
dispenser
1. Switch on the appliance. The appliance
must be in setting mode.
2. Press and hold function button (B) and
function button (C) simultaneously until
the indicators of function buttons (A),
(B) and (C) start to flash.
3. Release function button (B) and function
button (C).
4. Press function button (B), the indicators
of function buttons (A) and (C) go off
while the indicator of function button
(B) continues to flash. The display shows
the current setting.
Rinse aid dispenser
deactivated
Rinse aid dispenser
activated
5. Press function button (B) again. The
display shows the new setting.
6. Switch off the appliance to confirm the
operation.
26