Jensen MZ7TFT - Manual (Page 3)

MZ7TFT
3
Wiring
1. Align the ridges on either end of the combined input cable (VIDEO IN,
AUDIO L, AUDIO R, REAR TS, GROUND and ACC) and connect the
cable to the male connector on the back of the MZ7TFT. The connector
will only fit when the notched areas are properly aligned.
2. Connect the REAR TS connector to the MZ7-TFT connector on the back
of your compatible head unit (if applicable).
NOTE: You can connect up to three monitors to your compatible head
unit using the Touch Screen Expansion Module (included). See “Touch
Screen Expansion Module” on page 4 for instructions.
3. Connect the AUDIO R, AUDIO L and VIDEO IN connectors to the Video
and Audio output (Headphone Multizone) cables on the back of your
compatible head unit or to another auxiliary device for which you would
like to output video.
4. Connect the black GROUND wire to the factory ground wire on your head
unit, or to a clean, unpainted metal part of the automobile chassis using a
ring terminal and a sheet metal screw.
5. Connect the ACC wire to the factory accessory or ignition wire, which
receives power when the key is turned on.
Red
Yellow
White
Black
AUDIO R (right)
VIDEO IN
AUDIO L (left)
REAR TS
GROUND
ACC
FUSE
Figure 1: Wiring Connections