JVC CA-VSDT2000 - Manual (Page 8)

5
Getting Started
Connecting the AM Antenna
Rear Panel of the Center Unit (CA-VSDT2000)
• The AM loop antenna can be attached to a wall.
• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.
• Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord.
This could cause poor reception.
• If reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal. (Keep the AM loop
antenna connected.)
ANTENNA
OUT IN
SPEAKERS
SPEAKER IMPEDANCE 4 16
AC IN
AM
EXT
FM
(75 )
COAXIAL
AM
LOOP
R L
MD/AUX SUB
WOOFER
CD DIGITAL
OUT
H V
DISP.SET
Attach the AM loop to its base by snapping the tabs on
the loop into the slot in the base.
AM loop antenna (Supplied)
AM
EXT
FM
(75 )
COAXIAL
AM
LOOP
ANTENNA
Turn the loop until you have the best reception.
Outdoor single vinyl-
covered wire
(not supplied)
Screw (not supplied)
VS-DT2000(J)_EN.book Page 5 Wednesday, February 6, 2002 4:37 PM