JVC CA-VSDT2000 - Manual (Page 18)

15
Using the Powered Subwoofer
INPUT Terminals
The Subwoofer has the following INPUT terminals.
INPUT(LOW-LEVEL):
Usually, the LEFT/MONO terminal is connected to the SUBWOOFER terminal of the Center Unit with the supplied signal
cord. (see page 7.)
When the Center Unit CA-VSDT2000 is not used (Using other equipment)
If an amplifier etc. to be connected does not have the SUB WOOFER OUT terminals, the RIGHT and LEFT/MONO ter-
minals will be connected to the LINE OUT-RIGHT and LEFT terminals of that unit.
INPUT (HIGH-LEVEL):
You can connect the speaker output terminals of other amplifier etc. to these terminals.
Connect the speaker cords in parallel to the speaker terminals on the amplifier etc.
• Do not use the INPUT (LOW-LEVEL) terminals and the INPUT (HIGH-LEVEL) terminals at the same time.
LINE OUT
LEFT RIGHT
Connecting cord
(not supplied)
Amplifier etc.
SPEAKER
LEFT RIGHT Amplifier
etc.
Speaker cords
(not supplied)
VS-DT2000(J)_EN.book Page 15 Wednesday, February 6, 2002 4:37 PM