JVC CA-VSDT2000 - Manual (Page 27)

24
Using the Timers
6 Before turning off the System, prepare
the music source selected in step 3.
TUNER: Tune in to the desired station.
CD:
Insert a CD. (Playback will start from the first
track at Timer on.)
7 Press the
% button to turn off the Sys-
tem.
In standby mode, you can see the Timer indicator ( )
on the display.
• When the timer turns on, the Timer indicator starts
blinking and the prepared source in step 6 will be
played.
To confirm the timer setting
Press the CLOCK/TIMER button, then press the SET
button. Each setting appears on the display.
To cancel the timer
Press the CLOCK/TIMER button, then press the CAN-
CEL button. The Timer indicator (
) goes out.
To re-activate the cancelled timer
Press the CLOCK/TIMER button, then press the SET
button. The Timer indicator (
) appears.
To change the timer setting
Repeat the setting procedure from the beginning.
CAUTION:
• If the System is unplugged, or a power fail-
ure occurs, the timer setting will be lost.
You will need to reset the clock first, then
the timer.
Setting the SLEEP Timer
(Using the Remote Control)
Use the Sleep Timer to turn the System off after a certain
number of minutes when it is playing. By setting the Sleep
Timer, you can fall asleep to music and know that your Sys-
tem will turn off by itself rather than play all night.
■ You can only set the Sleep Timer when the System is on
and a source is playing.
1 Play a CD or tune in to the desired sta-
tion.
2 Press the SLEEP button on the Remote
Control.
The “SLEEP” indicator lights up.
■ When the clock is not set, “AM 12:00” appears on the
display. Set the clock at first.
3 Set the length of time you want the
source to play before shutting off.
• Each time you press the SLEEP button, it changes
the number of minutes shown on the display in this
sequence:
10 = 20 = 30 = 60 = 90 = 120 = Cancelled =
(back to the beginning)
The selected number of minutes for the Sleep Timer will
disappear five seconds later and the display returns to the
original one before setting the Sleep Timer. (The display is
dimmed.)
The System is now set to turn off after the number of min-
utes you set.
To Confirm the Sleep Time:
When the SLEEP button is pressed, the remaining sleep
time is displayed. Wait until the display returns to the orig-
inal display.
To Cancel the SLEEP Timer Setting:
Press the SLEEP button until the “SLEEP” indicator goes
out on the display.
Turning off the System also cancels the SLEEP Timer.
■ If you are setting the Daily Timer, the System will be
turned on at the set time to wake you up.
VS-DT2000(J)_EN.book Page 24 Wednesday, February 6, 2002 4:37 PM