JVC 0597TOV*UN*VP - Manual (Page 44)

44
USING REMOTE CONTROL UNIT (cont.)
M-0:23:45
COUNTER R/M
Insert Editing
You can record a new scene into a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio on the normal audio track remains
unchanged.
NOTE:
Use the RM-V704U or RM-V700U remote control unit to perform
this procedure.
SELECT MODE
1
Set the Power switch to “PLAY”.
FIND EDIT-OUT POINT
2 Play back the tape, locate the Edit-Out point and
press PAUSE on the camcorder or the remote control.
RESET COUNTER
3 Press and hold COUNTER R/M for more than
2 seconds to reset the tape counter, then press for
less than 1 second and make sure “M” appears in
the viewfinder.
FIND EDIT-IN POINT
4
Press REW to go a little beyond the beginning of the
scene you want to replace, press PLAY to view the
recorded tape, and press PAUSE at exactly at the
Edit-In point where the new scene should start.
ENGAGE INSERT EDITING MODE
5
Press and hold INSERT, and without releasing
INSERT, press and release PAUSE. The Insert mode
is engaged. When the scene the camcorder is aimed
at appears on the screen, go to the next step.
BEGIN INSERT EDITING
6 Press Recording Start/Stop. When the counter
reaches “0:00:00”, editing stops automatically and
the camcorder enters the Insert-Pause mode.
END INSERT EDITING
7
Press STOP.
NOTES:
● After step 5, Retake (
੬
pg. 15) can be performed.
● The tape may stop slightly before or after the
designated end point, and noise bars may appear.
Neither indicates a defect in the unit.
● Only video signal is recorded in the Insert Editing
mode.
Tape counter
Insert editing indicator
Viewfinder
PAUSE
INSERT
PLAY
REW
START/STOP
RM-V704U or RM-V700U
(provided)
POWER