JVC LVT0870-006A - Manual (Page 23)

20
When the shut-off time comes:
The receiver turns off automatically.
To check or change the time remaining until the shut-off time:
Press SLEEP once.
The remaining time until the shut-off time appears in minutes.
• To change the shut-off time, press SLEEP repeatedly.
To cancel the Sleep Timer:
Press SLEEP repeatedly until “SLEEP 0min” appears on the display.
(The SLEEP indicator goes off.)
• Turning off the power also cancels the Sleep Timer.
Muting the Sound
From the remote control ONLY:
Press MUTING to mute the sound through
all speakers and headphones connected.
“MUTING” appears on the display and the volume
turns off (the volume level indicator goes off).
To restore the sound, press MUTING again.
• Turning MASTER VOLUME on the front panel or pressing
VOLUME +/– on the remote control also restores the sound.
Changing the Display Brightness
You can dim the display.
From the remote control ONLY:
Press DIMMER.
• Each time you press the button, the display dims
and brightens alternately.
Using the Sleep Timer
Using the Sleep Timer, you can fall asleep while listening to music.
From the remote control ONLY:
Press SLEEP repeatedly.
The SLEEP indicator lights up on the display, and
the shut-off time changes in 10 minutes intervals.
The volume level
indicator goes off. Ex.: When the source is “DVD.”
ANALOG L R
SPEAKERS 1
Recording a source
For analog-to-analog recording
You can record any analog source through the receiver to—
• the cassette deck (or MD recorder) connected to the TAPE/MD
jacks,
• the VCRs connected to the VCR 1 and VCR 2 jacks, and
• the CD recorder connected to the CDR jacks
—at the same time.
For digital-to-digital recording
You can record the currently selected digital input source
through the receiver to a digital recording device connected to
the DIGITAL OUT terminal.
Notes:
• Analog-to-digital and digital-to-analog recordings are not
possible.
• The output volume level, Midnight Mode (see page 24), Bass
Boost (see page 31), digital equalization (see page 39),
Surround modes and DSP modes (see pages 32 to 36) cannot
affect the recording.
• The test tone signal (see pages 40 and 41) does not come out
through the DIGITAL OUT terminal.
Basic adjustment auto memory
This receiver memorizes sound settings for each source—
• when you turn off the power,
• when you change the source, and
• when you assign the source name (see page 17).
When you change the source, the memorized settings for the
newly selected source are automatically recalled.
The following can be stored for each source:
• Analog/digital input mode (see page 19)
• Input attenuator mode (see page 30)
• Analog Direct (see page 30)
• Speaker channel output levels (see pages 40 and 41)
• Digital equalization pattern (see page 39)
• Sound parameters (see page 42)
• Surround and DSP mode selection (see pages 35 and 36)
• Bass Boost setting (see page 31)
Notes:
• If the source is FM or AM, you can assign a different setting for
each band.
• If you want to memorize the volume level with the above
settings, set “ONE TOUCH (OPR)” to “ON” (see page 26).
MUTING
DIMMER
SLEEP
ANALOG
SLEEP VOLUME
L R
SPEAKERS 1
20 10 30 40 50 60 70 80 90
(Canceled) 0
Ex.: When the source is “DVD.”
EN16-20.RX-8020V[A]_f 02.5.21, 10:17 AM 20