JVC LVT0870-006A - Manual (Page 21)

18
MASTER VOLUME
Listening Only with Headphones
You can listen with the headphones without deactivating both pairs
of speakers by connecting a pair of headphones to the PHONES jack
on the front panel. If you want to use a pair of headphones without
outputting sounds from the front speakers, you must turn off both
pairs of the front speakers as mentioned above.
HEADPHONE mode
When using the headphones, the following signals are output
regardless of your speaker setting:
— For 2 channel software, the front left and right channel signals
are output directly from the headphones.
— For multi-channel software, the front left and right, center, and
surround channel signals are down-mixed and then output
from the headphones.
• If a DSP mode is activated, you can enjoy the DSP effects.
“3D H.PHONE” appears on the display and the DSP indicator
lights up on the display. (See page 34.)
Note:
In the following cases, the speakers connected to the FRONT
SPEAKERS 2 terminals are deactivated even if both pairs of the front
speakers are activated.
– If you select “DVD MULTI” as the source.
– If you select any of the Surround/DSP modes which activate the
center and/or surround speaker(s).
CAUTION:
Be sure to turn down the volume:
• Before connecting or putting on headphones, as its high volume can
damage both the headphones and your hearing.
• Before turning on speakers again, as its high volume may output
from the speakers.
+
−
VOLUME
Adjusting the Volume
On the front panel:
To increase the volume, turn MASTER
VOLUME clockwise.
To decrease the volume, turn it
counterclockwise.
From the remote control:
To increase the volume, press VOLUME +.
To decrease the volume, press VOLUME –.
CAUTION:
Always set the volume to the minimum before starting any sources. If
the volume is set at its high level, the sudden blast of sound energy
can permanently damage your hearing and/or ruin your speakers.
Notes:
• The volume level can be adjusted within the range of “0” (minimum)
to “70” (maximum).
• If you set One Touch Operation to “ON” (see page 26), you do not
have to adjust the volume level each time you change the source. It
is automatically set to the stored level.
Selecting the Front Speakers
On the front panel ONLY:
When you have connected two pairs of the front speakers, you can
select which to use.
To use the speakers connected to the
FRONT SPEAKERS 1 terminals, press
SPEAKERS ON/OFF 1 so that the
SPEAKERS 1 indicator lights up on the
display. Make sure that the SPEAKERS 2
indicator is not lit on the display.
To use the speakers connected to the FRONT SPEAKERS 2
terminals, press SPEAKERS ON/OFF 2 so that SPEAKERS 2
indicator lights up on the display. Make sure that the SPEAKERS 1
indicator is not lit on the display.
To use both sets of the speakers, press SPEAKERS ON/OFF 1 and
SPEAKERS ON/OFF 2 so that the SPEAKERS 1 and SPEAKERS 2
indicators light up on the display.
To use neither sets of the speakers, press SPEAKERS ON/OFF 1
and SPEAKERS ON/OFF 2 so that the SPEAKERS 1 and
SPEAKERS 2 indicators disappear from the display.
The HEADPHONE indicator lights up and “HEADPHONE”
appears on the display.
• Activating the speakers turns on the Surround and DSP modes
previously selected.
SPEAKERS ON/OFF
1
2
EN16-20.RX-8020V[A]_f 02.5.21, 10:16 AM 18