JVC CS-DA1 - Manual (Page 14)

10
ENGLISH
When using LINE IN terminal
[Connecting to line output]
NOTES:
• The volume of this unit is set to the maximum when the remote controller is not connected.
• If your receiver is equipped with the DSP (Digital Signal Processor), connect this unit to the front
speaker output of the receiver.
CS-DA1
15A
Blue/White
Remote input Remote output
L-shaped
pin plug
relay cord
Speaker
input
Power cord
Yellow
⅐ Connect only to the plus +
side of the battery.
Black
⅐ Connect to the metal part
(such as the chassis) of the
car.
Remote controller
Pin cord (not supplied)
Line output
Set the LPF switch to either
A110 HzB or A85 HzB according
to your preference. When no remote output is equipped for
your car receiver, connect to the ACC
power.
ACC power cord
Crimp connector
Fuse
This is not used when LINE IN
terminal is used.
JVC Car
receiver, etc.
TO
SPEAKER
INPUT
TO
REMOTE
OUT
POWER LEAD
GROUND
CS-DA1_EN.book Page 10 Wednesday, May 23, 2007 12:09 PM