JVC CS-DA1 - Manual (Page 12)

8
ENGLISH
Mounting on a commercially available board
After step 1, use screws to secure the unit on the commercially available board. In this case, the
mounting bracket C need not be used.
Attaching the remote controller
Do not place the remote controller where it will
be exposed to direct sunlight.
NOTE:
• Clean the item thoroughly before attaching.
How to use the wire clamp
To prevent the remote control cord or the L-
shaped pin plug relay cord from falling off due
to vibration, secure all cords with the attached
wire clamp after all connection is completed.
Horizontal installation Vertical installation
Tapping screw
(Dia. 3/16 inch c 13/16 inch
/ M 4 mm c 20 mm) c 4
Board (Commercially available
item: Thickness 23/32 inch / 18 mm and above) Board (Commercially available
item: Thickness 23/32 inch / 18 mm and above)
Tapping screw
(Dia. 3/16 inch c 13/16 inch
/ M 4 mm c 20 mm) c 4
Double-sided tape
Peel off the sheet
Wire clamp
Pull
Remote controller cord
leave a little longer
Allow the L-shaped
pin plug relay to sag
slightly
Power cord
CS-DA1_EN.book Page 8 Wednesday, May 23, 2007 12:09 PM