JVC CS-DA1 - Manual (Page 10)

6
ENGLISH
Procedures for horizontal installation
1
Mount mounting brackets A and
B at the back of the unit
2
Tighten screws on mounting
bracket C and attach a cushion
to it
• Assemble two mounting brackets C.
3
Make a hole in the carpet, place
the assembled mounting
brackets C below and secure
with butterfly nuts
• Use the paper pattern to determine the
positions.
Mounting screw
(Dia. 7/32 inch c 11/32 inch
/ M 5 mm c 8 mm) c 4
Mounting
bracket A
Mount such
that the
letter
AAB is
at the
bottom.
Mount such
that the letter
ABB is at the
bottom.
Mounting bracket B
Mounting bracket C
Mounting screw
(Dia. 7/32 inch c 1 inch /
M 5 mm c 25 mm) c 2
Cushion
Peel off the sheet
CAUTION
If the cushion is not attached to the
mounting bracket C, you will hear a
scrapping sound when the unit comes into
contact with the car body as the car moves
and vibrates.
Butterfly nut
(Dia. 7/32 inch / M 5 mm) c 4
Spring washer
(Dia. 7/32 inch /
M 5 mm) c 4
Carpet etc.
Use a cutter
to make 4
holes.
Mounting bracket C (c2)
assembled in step 2
11-
13/3
2 in
ch
(28
9 m
m)
1-1
/8
inc
h
(28
m
m)
CS-DA1_EN.book Page 6 Wednesday, May 23, 2007 12:09 PM