Jura Capresso F707 - Manual (Page 18)

18
15. Programming
When your IMPRESSA leaves the factory it is adjusted such that
you can draw off coffee without having to change any settings.
However, you can programme various para meters individually.
You can programme the following stages:
¼ Filter
¼ Water hardness
¼ Maintenance
¼ Aroma
¼ Temperature
¼ Time
¼ Automatic switch-on time
¼ Automatic switch-off time
¼ Draw-offs
¼ Language
¼ Display
¼ Exit
To start programming, press the Rotary Switch (1) until
FILTER – / ߛ appears
Rotary switch
Turn the Rotary Switch to change the adjusted values or to
select the next programming step.
Press the Rotary Switch to check the values adjusted or to save
the values selected (Fig. 17).
15.1 Programming the filter
Refer to Chapter 5.1 ‘Inserting the filter’.
15.2 Programming the water hardness
Refer to Chapter 4 ‘Adjusting the water hardness’.
15.3 Maintenance menu
Ⅲ
READY
Ⅲ Press the Rotary Switch (1) until
FILTER – /
ߛ appears
Ⅲ The illuminated ring (2) is active.
Ⅲ Turn the Rotary Switch (1) until
MAINTENANCE appears
Ⅲ Press the Rotary Switch (1)
Ⅲ
RINSE
Ⅲ Turn the Rotary Switch (1) until the required program item appears
on the display (9).
Ⅲ e.g. RINSE, CLEAN, FILTER, DE-SCALE or EXIT
Ⅲ
e.g. CLEAN
Ⅲ Press the Rotary Switch (1)
Ⅲ The cleaning program starts.
Ⅲ
EMPTY TRAY
Ⅲ Continue with Chapter 17 Cleaning, from point 3
EMPTY TRAY
15.4 Programming the aroma INTENSIVE
or STANDARD
When the machine leaves the factory, the aroma is set to
intensive. If requested it can also be set to Standard.