Jet Tools JOB SITE TABLE SAW JBTS-10MJS - Manual (Page 16)

16
Installing the Push-stick Storage
Attach the metal push-stick storage bracket (Figure 13)
into the provided slot (D, Fig. 14) on the right side of the
body shell. The bracket will snap into place.
Storage
Rip fence and miter gauge
Storage brackets for the rip fence (B, Fig. 14) and
miter gauge (C, Fig. 14) are located on the right
side of the saw housing.
Note: Adjust the miter gauge to 45º-60º before
putting away in storage.
Blade wrench
Insert the handle of the blade wrench (A, Fig. 14)
into the slot located to the right side of the saw
housing.
Blade
1. Loosen and remove the knob (A, Fig. 15) on
the left side of the saw housing.
2. Place extra blades (B, Fig. 15) onto the
bushing. Replace the knob and tighten.
Figure 13
Figure 14
Figure 15
D