JVC TH-V70R - Manual (Page 79)

74
SOLUTION
Connect the cord correctly.
(See page 13.)
Adjust the balance properly.
(See pages 63 and 70.)
Set the speaker setting properly.
(See pages 64 and 70.)
Switch the power off, and remove
and re-insert the power plug in the
socket.
Switch the power off and leave the
unit a few hours before switching
the power on again.
Connect the cord correctly.
(See page 10.)
Set it proper for the connection and
your TV. (See page 10.)
Select the correct input on the TV.
Use a playable disc. (See page 6.)
Replace the disc. (See page 6.)
Enter password to change the
parental level. (See page 68.)
Insert the disc correctly.
(See page 28.)
Replace the disc. (See page 6.)
Replace or clean the disc.
(See page 72.)
Connect the center unit and TV
directly.
Change “STILL MODE.”
(See page 62.)
Set the monitor type correctly.
(See page 62.)
Set the TV correctly.
Some DVDs are programmed to
always display no subtitle initially. If
this happens, press SUBTITLE on
the remote control after starting
play. (See page 45.)
Some DVDs are programmed to
always use the original language
initially. If this happens, press
AUDIO on the remote control after
starting play. (See page 46.)
DVD Playback
POSSIBLE CAUSE
The speaker cord is not connected
correctly.
Left-right balance is not set properly.
The speaker setting is incorrect.
Lightning or electronic noise interferes
with operation of the microcomputer.
Immediately after beginning to heat the
room, the system was moved to a cold
location causing condensation to form
inside.
The video cord or SCART cable is not
connected correctly.
The RGB-Y/C selector is not set correctly.
TV input selection is incorrect.
The disc is not playable.
The system’s and disc’s Region Code
numbers are incompatible.
Parental Lock is in use.
The disc is inserted with its label and
data sides inverted.
The unplayable disc is inserted.
The disc is scratched or dirty.
A VCR is connected between the center
unit and the TV.
“STILL MODE” may not be set
appropriately for the current disc.
“MONITOR TYPE” is not set correctly.
The TV is not set correctly.
PROBLEM
Sound from one front speaker only.
No sound from the center and/or rear
speakers.
The system does not work correctly.
No picture is displayed on the TV
screen.
A disc cannot be played.
A disc cannot be played and “0:00” is
displayed on the display window.
Video and audio are distorted.
The picture does not fit the TV screen.
No subtitle appears on the TV screen
though you have selected as your
initial subtitle language.
Audio language is different from the
one you have selected as your initial
audio language.
General
EN71-78TH-V70R[B]ff.pm6 02.5.16, 6:56 PM 74