JVC TH-V70R - Manual (Page 22)

17
When attaching the center unit to a wall
You can attach the center unit to a wall.
CAUTIONS: location of attachment to a wall
• Take care when selecting a location for attaching the center unit to the wall. Injury to personnel, or damage to the center
unit, may result if the center unit is attached in a location which interferes with daily activities, or a location that the users
are liable to knock their bodies or heads against the center unit.
• Avoid a location above a bed, sofa, water tank, sink, etc. or in a passage.
CAUTIONS: attachment to a wall
• The center unit weighs approximately 2.95 kg. When you operate the buttons on the center unit, an additional force will be
applied to the center unit in downward direction. Therefore, sufficient care must be required when attaching the center unit
to a wall to prevent any accidents caused by the unit’s falling off.
• Before attaching the center unit to a wall, check the wall (or other related aspects) you want to attach it to, and verify
whether the strength of the wall will be sufficient not only to support the weight of the center unit itself but also to withstand
the additional downward force which will be applied to it during operations.
(Do not attach the center unit to a plywood or plasterboard wall. The center unit will fall and sustain damage as a result.)
If you cannot judge the strength of the wall or other aspects, consult a qualified person (such as a qualified constructor).
• The screws needed for attachment are not supplied. Use screws which are compatible with the strength and material of the
pillar or wall.
• When attaching the center unit, the screws must be secured tightly in all three locations. Failure in attaching the center unit
to the wall using all three holes on the back of the center unit makes for an unstable attachment, and it constitutes a safety
hazard as the center unit may fall down.
Example of attachment
The procedure below is an example of how to attach the center unit to a wall:
It dose not make any guarantee for safety while using the center unit on the wall. Take into account such factors as the
material, strength, and the status of the wall as well as the reinforcing material, and the possible changes that will take place
over time.
NOTES:
• You need to connect the cords to the center unit (and attach the supplied stand) before attaching it to the wall.
• DO NOT plug the power cord into an AC outlet before attaching the center unit to the wall.
• When attaching the supplied stand to the center unit, connect the system cord, video cord, and so on by passing them through the holes at
the bottom of the stand, and do not attach the legs to the stand. See page 9.
1 Select the place where the center unit is to be attached.
2 Mount three screws (not supplied) to the wall.
Use the screws as illustrated below.
You can use the supplied paper pattern to mark the positions where the screws are mounted.
Getting started
Screws (not supplied)
Wall
Keep the space of 6 to 7 mm.
20 to 30 mm
3 mm
Within 3 mm
6 to 9 mm
EN1-20TH-V70R[B]1 02.3.12, 6:32 PM 17