John Deere POWERTECH 4045 - Manual (Page 102)

Engine Operation - Except 4.5L “270” Engines
OURGP11,0000075 –19–27JUL06–2/4
RG8028A –UN–15JAN99
Crosshatch Pattern On Dipstick
A—Crosshatch Pattern On Dipstick
IMPORTANT: DO NOT add makeup oil until the oil
level is BELOW the ADD mark on
dipstick. John Deere ENGINE BREAK-IN
OIL (TY22041) should be used to make
up any oil consumed during the
break-in period.
3. Check engine oil level more frequently during engine
break-in period. If oil must be added during this period,
John Deere ENGINE BREAK-IN OIL is preferred. See
ENGINE BREAK-IN OIL, in Fuels, Lubricants, and
Coolant Section.
IMPORTANT: Do not use PLUS-50 oil or engine oils
meeting any of the following during the
first 100 hours of operation of a new or
rebuilt engine:
API CI-4 PLUS ACEA CF
API CI-4 ACEA E7
API CH-4 ACEA E6
API CG-4 ACEA E5
API CF-4 ACEA E4
API CF-2 ACEA E3
These oils will not allow the engine to
break-in properly.
IMPORTANT: DO NOT fill above the crosshatch
pattern (A) or the FULL mark, whichever
is present. Oil levels anywhere within
the crosshatch are considered in the
acceptable operating range.
Specification
Engine—Oil Pressure at Full
Load Rated Speed With Oil
Warmed to 115
°
C (240
°
F) 345
±
103 kPa (3.45
±
1.03 bar)
(50
±
15 psi)
.....................
Minimum Oil Pressure at Slow
Idle Speed
105 kPa (1.05 bar) (15 psi) ......................................................
Coolant Temperature Range 82
°
–94
°
C (180
°
–202
°
F) ................................
Continued on next page
19-2
080706
PN=100