JVC VN-685U User Manual
Page 71
71
E
Preset Position
Speed
This item sets the speed of moving to the preset position. It is also applicable
when moving to the preset position in Auto Patrol.
Speed
[Setting value:1 to 4]
F
Auto Flip
Set this item when shooting objects that pass right under the camera.
Otherwise, following operations are necessary to shoot objects that pass
right under the camera.
ATurn the camera to face down
BRotate the camera 180 ° horizontally
CTurn the camera to face up
You can use the [Auto Flip] function to perform the above operations
automatically.
Off
: Auto Flip function does not activate.
Digital Flip
: The top/bottom and left/right of the image flips when tilt
position passed the angle of 135 degrees.
Mode1
: When the camera faces bottom, it rotates 180 °
horizontally and stops. In this case, the operating direction
of the camera is the same as that of the Pan/Tilt operation.
Mode2
: When the camera faces bottom, it rotates 180 °
horizontally and the operating direction of the camera is
opposite that of the Tilt operation. Select this mode if you
wish to operate continuously. Once operation stops, the
direction will return to normal.
Mode3
: When the camera faces bottom, it rotates 180 °
horizontally and the operating direction of the camera is
opposite that of the Tilt operation. However, the operating
direction will return to normal 10 seconds after the
operation has stopped.
[Setting value:Off, Digital Flip, Mode1, Mode2, Mode3]
Memo
:
● [Intelligent Tracking] is disabled when this is set to ADigital FlipB.
● Settings for [Preset Position Speed] are reflected in the rotation speed
when images are flipped using
AMode1B, AMode2B, AMode3B. To flip
images in high speed using
AMode1B, AMode2B, AMode3B, set the
[Speed] in [Preset Position Speed] to
A4B.
Note:
● When [Auto Flip] is set to other than AOffB, the camera can be moved to
areas outside the pan limit with the Tilt operation. When
ADigital FlipB is
set, use the Tilt operation to flip and return to the pan limit area again.
When
AMode1B, AMode2B or AMode3B is set and the camera is moved to
inside of the pan limit with Pan operation, it will stop at the pan limit
position.